This 10/100Base Ethernet to 100Base-FX fiber media
converter is designed for CPE applications when
installed in or connection to the RC-CH-11-x unmanaged
media converter platform or in stand-alone point to
point applications. The converter supports auto negotiation
on the copper Ethernet side as well as
forced mode. With advanced features like LFP (Link
Fault Pass-thru), FEF (Far-End Fault), Switch mode
(store & forward,1600 Bytes maximum frame size) or
Converter mode (100/Full to 100/Full, low latency, 9K
Bytes packet support), this media converter is targeted
for customer premises equipment in metro LAN,
campus, enterprise and FTTx applications. By
offering simple DIP switch settings, this converter can
provide complete control over all converter settings
including duplex and speed configuration. This media
converter is completely transparent to Layer 2 and Layer
3 protocols including IEEE 802.1q, VLAN tag, Q in Q,
STP, IPX, IP, etc.

Auto-Cross over for MDI/MDIX in TP port
Supports far end fault (FEF) function
Auto-Negotiation or Manual mode in TP port
Supports link fault pass through (LFP) function
Support LED indicators
Support Converter mode or switch mode function
   operation
Packet lengths up to 1600 bytes in Switch mode, or
   the packet length is not limited in Converter mode
Extremely lightweight due to the designed plastic cover.
 

IEEE 802.3 10BASE-T
IEEE 802.3u 10/100BASE-TX/FX

Interface

1 x 10/100Mbps RJ-45 port
1 x 100Mbps FX port (SC/UPC)
100BASE-FX (Tx1310nm)